User Tools

Site Tools


doc:hardware:port.gpio
This wiki is read only and for archival purposes only. >>>>>>>>>> Please use the new OpenWrt wiki at https://openwrt.org/ <<<<<<<<<<

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
doc:hardware:port.gpio [2017/08/16 14:39]
danitool [Finding GPIO pins (input) on the PCB]
doc:hardware:port.gpio [2017/09/17 15:54]
Lin-Buo-Ren [Hardware] Fix typoes
Line 8: Line 8:
  
 ===== Hardware ===== ===== Hardware =====
-GPIOs are commonly used in router devices for buttons or leds. They only safely supply or sink (pull to GND) a maximum of 4mA aprox., and the voltage is usually 3.3V when active. Only two states are posible: high or low. Depending on how a device is activated by a GPIO, active low or active high is defined.+GPIOs are commonly used in router devices for buttons or leds. They only safely supply or sink (pull to GND) a maximum of 4mA approx., and the voltage is usually 3.3V when active. Only two states are possible: high or low. Depending on how a device is activated by a GPIO, active low or active high is defined.
  
   * **Active high**: the device is activated when the GPIO is HIGH   * **Active high**: the device is activated when the GPIO is HIGH
doc/hardware/port.gpio.txt · Last modified: 2017/09/18 18:43 by tmomas