You may need to disable the UART, to be able to use the TX and RX as GPIO-pin. The fact that the processors AR71xx/AR913x/AR724X/AR933X - UART default is locked and uses internal resources (buffer interrupt) for interaction with the driver.
So, it is possible to turn off the built-in UART by simple script, without the NO need to patch/recompile firmware.
opkg update && opkg install ioor use this installation method:
cd /tmp wget http://downloads.openwrt.org/barrier_breaker/14.07/ar71xx/generic/packages/oldpackages/io_1_ar71xx.ipk opkg install io_1_ar71xx.ipk
Create an empty file (if it is from the console):
Paste the script in empty file:
#!/bin/sh # Bitwise operations: & = And, | = Or, ^ = xOr, << = Left Shift detect_addr="0x18060090" rev_id_maj_msk="0xfff0" func_addr="0x18040028" bit1="1<<1" # using bit1 for AR724x/AR933x bit8="1<<8" # using bit8 for AR71xx/AR913x detect_value=0x`io -4 $detect_addr | cut -f3 -d' '` detected_result=$(printf "0x%4.4x" $(($detect_value & $rev_id_maj_msk))) func_value=0x`io -4 $func_addr | cut -f3 -d' '` # depending on the detected rev_id of CPU - # it will be use specific bit# as case_bit variable, or exit case "$detected_result" in # AR7240/AR7241/AR7242/AR9330/AR9331 0x00c0 | \ 0x0100 | \ 0x1100 | \ 0x0110 | \ 0x1110 ) case_bit=$bit1 ;; # AR71xx/AR913x 0x00a0 | \ 0x00b0 ) case_bit=$bit8 ;; # AR9341/AR9342/AR9344 0x0120 | \ 0x1120 | \ 0x2120 ) echo -e "No need to disable UART on AR934x processors,\n \ just use sysfs to reprogram GPIOs." break exit 0 ;; * ) echo "Can't detect your CPU, must be Atheros!" break exit 1 ;; esac # we using Bitwise xOr operation to switching bit# state (0 or 1) io -4 $func_addr $(printf "0x%8.8x" $(($func_value ^ $case_bit))) # read bit# state and depending on the state - print some info if [ $(($func_value & $case_bit)) = $(($case_bit)) ]; then echo "Hardware UART is turned OFF" # You can use this line for automatic configuring GPIOs via sysfs # or you can load other modules that use these GPIOs else echo "Hardware UART is turned ON" fi
Assign the right execution:
chmod +x /usr/sbin/uart_gpio
And actually the launch itself uart_gpio (if launch again it turn on UART back) …
Of course, it turn off UART until the next reboot the device, ie, you need to automate the process, for example by writing command in /etc/rc.local. After that you need and you can configure for yourself GPIO via /sys/class/gpio/export… well, I think it is not necessary to go into details, because who need to turn off the UART for some purposes - he will understand.
Let me remind you, for AR724x/AR933x:
UART_IN | UART_OUT GPIO9 | GPIO10