Speedport W500V
The Speedport W500V is a Broadband Router with integrated DSL Modem, WLan Module and ISDN + Analog PBX capability for VoIP. Manufactured by Hitachi High Technologies and OEM'ed primarily through the T-Com in germany.
The device is also sold by Lidl under the name Targa WR 500 VoIP.
What makes the Speedport W500V a quite attractive device is the PBX part. It can route incoming calls from either landline and VoIP onto the connected analog phones. Comparable to what the AVM FritzBox FON Routers can do. For outgoing rules can be set to either route the call into landline or over a VoIP SIP Provider.
OpenWrt
- You need these patches:
- WiFi is working in AP mode (wpa and wpa2) with the wl driver
Bootlog
CFE version 1.0.37-0.6 for BCM96348 (32bit,SP,BE)
Build Date: Fri Jun 10 10:59:26 CST 2005 (root@localhost.localdomain)
Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.
Initializing Arena.
Initializing Devices.
Auto-negotiation timed-out
10 MB Half-Duplex (assumed)
CPU type 0x29107: 256MHz, Bus: 128MHz, Ref: 32MHz
Total memory used by CFE: 0x80401000 - 0x80522C70 (1186928)
Initialized Data: 0x8041ADD0 - 0x8041C610 (6208)
BSS Area: 0x8041C610 - 0x80420C70 (18016)
Local Heap: 0x80420C70 - 0x80520C70 (1048576)
Stack Area: 0x80520C70 - 0x80522C70 (8192)
Text (code) segment: 0x80401000 - 0x8041ADC4 (105924)
Boot area (physical): 0x00523000 - 0x00563000
Relocation Factor: I:00000000 - D:00000000
Board IP address : 192.168.1.1:ffffff00
Host IP address : 192.168.1.100
Gateway IP address :
Run from flash/host (f/h) : f
Default host run file name : vmlinux
Default host flash file name : bcm963xx_fs_kernel
Boot delay (0-9 seconds) : 1
Board Id Name : 96348GW
Psi size in KB : 32
Number of MAC Addresses (1-32) : 11
Base MAC Address : 00:03:c9:b1:6e:fc
Ethernet PHY Type : Internal
Memory size in MB : 16
* Press any key to stop auto run (1 seconds) *
Auto run second count down: 0
Code Address: 0x80010000, Entry Address: 0x80010000
Decompression OK!
Entry at 0x80010000
Closing network.
Starting program at 0x80010000
Linux version 2.6.32.14 (alex@fob) (gcc version 4.3.3 (GCC) ) #4 Fri Jul 9 15:35:57 CEST 2010
Detected Broadcom 0x6348 CPU revision a2
CPU frequency is 256 MHz
16MB of RAM installed
registering 37 GPIOs
board_bcm963xx: CFE version: 1.0.37-0.6
bootconsole [early0] enabled
CPU revision is: 00029107 (Broadcom BCM6348)
board_bcm963xx: board name: SPW500V
Determined physical RAM map:
memory: 01000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 0x00000000 → 0x00001000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 → 0x00001000
Built 1 zonelists in Zone order, mobility grouping off. Total pages: 4064
Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200
PID hash table entries: 64 (order: -4, 256 bytes)
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Primary instruction cache 16kB, VIPT, 2-way, linesize 16 bytes.
Primary data cache 8kB, 2-way, VIPT, no aliases, linesize 16 bytes
Memory: 13432k/16384k available (2064k kernel code, 2952k reserved, 366k data, 140k init, 0k highmem)
Hierarchical RCU implementation.
NR_IRQS:128
Calibrating delay loop… 254.97 BogoMIPS (lpj=509952)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
registering PCI controller with io_map_base unset
bio: create slab <bio-0> at 0
Switching to clocksource MIPS
PCI: Enabling device 0000:00:01.0 (0000 → 0002)
ssb: Sonics Silicon Backplane found on PCI device 0000:00:01.0
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
NET: Registered protocol family 1
audit: initializing netlink socket (disabled)
type=2000 audit(0.312:1): initialized
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
msgmni has been set to 26
io scheduler noop registered
io scheduler deadline registered (default)
gpiodev: gpio device registered with major 254
bcm63xx_uart.0: ttyS0 at MMIO 0xfffe0300 (irq = 10) is a bcm63xx_uart
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
bcm963xx_flash: 0x00400000 at 0x1fc00000
bcm963xx: Found 1 x16 devices at 0x0 in 16-bit bank
CFI mfr 0x000000c2
CFI id 0x000022a7
Amd/Fujitsu Extended Query Table at 0x0040
Amd/Fujitsu Extended Query version 1.1.
bcm963xx: Swapping erase regions for broken CFI table.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
bcm963xx_flash: Read Signature value of CFE1CFE1
bcm963xx_flash: CFE bootloader detected
bcm963xx_flash: CFE boot tag found with version 6 and board type 96348GW
bcm963xx_flash: Partition 0 is CFE offset 0 and length 10000
bcm963xx_flash: Partition 1 is kernel offset 10100 and length dff00
bcm963xx_flash: Partition 2 is rootfs offset f0000 and length 300000
bcm963xx_flash: Partition 3 is nvram offset 3f0000 and length 10000
bcm963xx_flash: Partition 4 is linux offset 10000 and length 3e0000
bcm963xx_flash: Spare partition is 330000 offset and length c0000
Creating 5 MTD partitions on "bcm963xx":
0x000000000000-0x000000010000 : "CFE"
0x000000010100-0x0000000f0000 : "kernel"
mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block – forcing read-only
0x0000000f0000-0x0000003f0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=330000, len=C0000
0x000000330000-0x0000003f0000 : "rootfs_data"
0x0000003f0000-0x000000400000 : "nvram"
0x000000010000-0x0000003f0000 : "linux"
bcm63xx_enet MII bus: probed
bcm63xx_wdt started, timer margin: 30 sec
Registered led device: power:red
Registered led device: power:green
Registered led device: ppp
Registered led device: pstn
Registered led device: voip
TCP westwood registered
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear greearb@candelatech.com
All bugs added by David S. Miller davem@redhat.com
VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
Freeing unused kernel memory: 140k freed
Please be patient, while OpenWrt loads …
- preinit -
Press the [f] key and hit [enter] to enter failsafe mode
- regular preinit -
switching to jffs2
mini_fo: using base directory: /
mini_fo: using storage directory: /overlay
- init -
Please press Enter to activate this console. NET: Registered protocol family 10
lo: Disabled Privacy Extensions
bcm63xx_enet bcm63xx_enet.0: attached PHY at address 1 [Broadcom BCM63XX (1)]
ADDRCONF(NETDEV_UP): eth0: link is not ready
Compat-wireless backport release: compat-wireless-2010-06-17-6-g8a97897
Backport based on wireless-2.6.git v2.6.35-rc3-47473-gd412296
cfg80211: Calling CRDA to update world regulatory domain
eth0: link UP - 100/full - flow control off
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
cfg80211: World regulatory domain updated:
(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
(2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
(2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
(5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
(5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
wl: module license 'unspecified' taints kernel.
Disabling lock debugging due to kernel taint
wl0: Broadcom BCM4318 802.11 Wireless Controller 5.10.56.27
PPP generic driver version 2.4.2
ip_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 24
nf_conntrack version 0.5.0 (212 buckets, 848 max)
ip6_tables: (C) 2000-2006 Netfilter Core Team
|
inbox/speedport.w500v.txt · Last modified: 2011/08/30 00:54 by orca