There is no running OpenWrt up to now!

The original sources can be requested on the homepage for this router.

And the sources for the Siemens SE515 are availible.

They contains the same board, but siemens ships it with a different case and firmware. By default, Dynalink puts in an Annex A firmware, while Siemens uses Annex B.

/!\ boot_wait should be on by default.

You can check it looking at the "Test" led on boot. If it lights for about 5 seconds, boot_wait is on.

/!\ THIS PORT IS STILL EXPERIMENTAL

Nothing will work, at the moment there is only a kernel that boots. Stop. There is need for testers.

A serial port (TTL levels, you need a TTL/232 level shifter, very simple to build) can be found inside it. The pinout refers to the board seen from above, with connectors on top and leds on bottom.

Serial connector

   1 2 3 4
   _______
  |o o o o|
   --   --

1) Vcc (3.3V)
2) GND
3) Tx (data from the router to the serial port)
4) Rx (data from the serial port to the router)

CategoryModel CategoryBCM63xx