Table of Contents

USR9108

WIP. Supported in OpenWrt (trunk), CPU is Mips32 in BCM6348, 4MB flash, 16MB ram, minipci-wlan (Broadcom 4318), USB-Host (1.1, ohci). No dsl drivers.

sysinfo

# cat /proc/cpuinfo
system type             : 96348GW-B
processor               : 0
cpu model               : BCM6348 V0.7
BogoMIPS                : 255.59
wait instruction        : no
microsecond timers      : yes
tlb_entries             : 32
extra interrupt vector  : yes
hardware watchpoint     : no
VCED exceptions         : not available
VCEI exceptions         : not available

Serial Port

There is a serial port next to the Broadcom CPU - 4pin pad. (115200 8N1: TX,RX,NC,GND)

Bootlog

CFE version 1.0.37-4.3 for BCM96348 (32bit,SP,BE)
Build Date: Tue Jan 17 07:46:56 CST 2006 (root@new-host-2)
Copyright (C) 2000-2005 Broadcom Corporation.

Boot Address 0xbfc00000

Initializing Arena.
Initializing Devices.
Parallel flash device: name M29W320ET, id 0x2256, size 4096KB
CPU type 0x29107: 256MHz, Bus: 128MHz, Ref: 32MHz
Total memory: 16777216 bytes (16MB)

Total memory used by CFE:  0x80401000 - 0x805252C0 (1196736)
Initialized Data:          0x8041C590 - 0x8041EA50 (9408)
BSS Area:                  0x8041EA50 - 0x804232C0 (18544)
Local Heap:                0x804232C0 - 0x805232C0 (1048576)
Stack Area:                0x805232C0 - 0x805252C0 (8192)
Text (code) segment:       0x80401000 - 0x8041C590 (112016)
Boot area (physical):      0x00526000 - 0x00566000
Relocation Factor:         I:00000000 - D:00000000

Board IP address                  : 192.168.1.1
Host IP address                   : 192.168.1.100
Gateway IP address                :
Run from flash/host (f/h)         : f
Default host run file name        : vmlinux
Default host flash file name      : bcm963xx_fs_kernel
Boot delay (0-9 seconds)          : 1
Board Id Name                     : 96348GW-A
Psi size in KB                    : 24
Number of MAC Addresses (1-32)    : 11
Base MAC Address                  : 00:14:c1:xx:xx:xx
Ethernet PHY Type                 : External Switch Using Reverse MII
Memory size in MB                 : 16
Country code                      : FR

*** Press any key to stop auto run (1 seconds) ***
Auto run second count down: 0
Code Address: 0x80010000, Entry Address: 0x80010000
Decompression OK!
Entry at 0x80010000
Closing network.
Starting program at 0x80010000
Linux version 2.6.27.13 (user@debian) (gcc version 4.1.2) #13 Sun Feb 8 10:53:18 CET 2009
Detected Broadcom 0x6348 CPU revision b0
CPU frequency is 256000000 Hz
16MB of RAM installed
board_bcm963xx: CFE version: 1.0.37-4.3
console [early0] enabled
CPU revision is: 00029107 (Broadcom BCM6348)
board_bcm963xx: board name: 96348GW-A
Determined physical RAM map:
 memory: 01000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
  Normal   0x00000000 -> 0x00001000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
    0: 0x00000000 -> 0x00001000
Built 1 zonelists in Zone order, mobility grouping off.  Total pages: 4064
Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 init=/etc/preinit noinitrd console=ttyS0,115200
Primary instruction cache 16kB, VIPT, 2-way, linesize 16 bytes.
Primary data cache 8kB, 2-way, VIPT, no aliases, linesize 16 bytes
PID hash table entries: 64 (order: 6, 256 bytes)
Dentry cache hash table entries: 2048 (order: 1, 8192 bytes)
Inode-cache hash table entries: 1024 (order: 0, 4096 bytes)
Memory: 13720k/16384k available (1866k kernel code, 2664k reserved, 323k data, 120k init, 0k highmem)
Calibrating delay loop... 254.97 BogoMIPS (lpj=509952)
Mount-cache hash table entries: 512
net_namespace: 592 bytes
NET: Registered protocol family 16
registering 37 GPIOs
registering PCI controller with io_map_base unset
bus: 00 index 0 io port: [8000000, 800ffff]
bus: 00 index 1 mmio: [30000000, 37ffffff]
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 512 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 512 bind 512)
TCP reno registered
NET: Registered protocol family 1
audit: initializing netlink socket (disabled)
type=2000 audit(0.276:1): initialized
squashfs: version 3.0 (2006/03/15) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY)  © 2001-2006 Red Hat, Inc.
msgmni has been set to 26
io scheduler noop registered
io scheduler cfq registered (default)
bcm63xx_uart.0: ttyS0 at MMIO 0xfffe0300 (irq = 10) is a bcm63xx_uart
console handover: boot [early0] -> real [ttyS0]
bcm63xx_enet MII bus: probed
bcm963xx_flash: 0x00400000 at 0x1fc00000
bcm963xx: Found 1 x16 devices at 0x0 in 16-bit bank
 Amd/Fujitsu Extended Query Table at 0x0040
bcm963xx: Swapping erase regions for broken CFI table.
number of CFI chips: 1
cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
bcm963xx_flash: Read Signature value of CFE1CFE1
bcm963xx_flash: CFE bootloader detected
bcm963xx_flash: CFE boot tag found with version 6 and board type 96348GW-A.
bcm963xx_flash: Partition 0 is CFE offset 0 and length 10000
bcm963xx_flash: Partition 1 is kernel offset 10100 and length bb46b
bcm963xx_flash: Partition 2 is rootfs offset d0000 and length 320000
bcm963xx_flash: Partition 3 is nvram offset 3f0000 and length 10000
Creating 4 MTD partitions on "bcm963xx":
0x00000000-0x00010000 : "CFE"
0x00010100-0x000cb56b : "kernel"
mtd: partition "kernel" doesn't start on an erase block boundary -- force read-only
0x000d0000-0x003f0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=280000, len=170000
0x00280000-0x003f0000 : "rootfs_data"
0x003f0000-0x00400000 : "nvram"
TCP bic registered
NET: Registered protocol family 17
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 120k freed
Please be patient, while OpenWrt loads ...
Algorithmics/MIPS FPU Emulator v1.5
- preinit -
Press CTRL-C for failsafe
switching to jffs2
mini_fo: using base directory: /
mini_fo: using storage directory: /jffs
- init -

Please press Enter to activate this console.
bcm63xx_enet bcm63xx_enet.0: attached PHY at address 1 [Broadcom BCM63XX (1)]
bcm63xx_enet bcm63xx_enet.0: attached PHY at address 1 [Broadcom BCM63XX (1)]
eth1: link forced UP - 100/full - flow control off/off
device eth1 entered promiscuous mode
br-lan: topology change detected, propagating
br-lan: port 1(eth1) entering forwarding state
br-lan: port 1(eth1) entering disabled state
br-lan: topology change detected, propagating
br-lan: port 1(eth1) entering forwarding state
ieee80211: 802.11 data/management/control stack, git-1.1.13
ieee80211: Copyright (C) 2004-2005 Intel Corporation 
cfg80211: Using static regulatory domain info
cfg80211: Regulatory domain: US
	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
	(2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 mBm)
	(5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
	(5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
	(5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
	(5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
	(5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 mBm)
cfg80211: Calling CRDA for country: US
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
PCI: Enabling device 0000:00:01.0 (0000 -> 0002)
b43-phy0: Broadcom 4318 WLAN found (core revision 9)
Broadcom 43xx driver loaded [ Features: PL, Firmware-ID: FW13 ]
ip_tables: (C) 2000-2006 Netfilter Core Team
Driver 'sd' needs updating - please use bus_type methods
nf_conntrack version 0.5.0 (1024 buckets, 4096 max)
CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Plase use
nf_conntrack.acct=1 kernel paramater, acct=1 nf_conntrack module option or
sysctl net.netfilter.nf_conntrack_acct=1 to enable it.
bcm63xx_ohci bcm63xx_ohci.0: BCM63XX integrated OHCI controller
bcm63xx_ohci bcm63xx_ohci.0: new USB bus registered, assigned bus number 1
bcm63xx_ohci bcm63xx_ohci.0: irq 20, io mem 0xfffe1b00
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.



BusyBox v1.11.3 (2009-02-03 18:31:56 CET) built-in shell (ash)
Enter 'help' for a list of built-in commands.

  _______                     ________        __
 |       |.-----.-----.-----.|  |  |  |.----.|  |_
 |   -   |   _  |  -__|     |   |  |  |    _|    _|
 |_ ^ |_____|__| ^ ^ |  |____|
          |__| W I R E L E S S   F R E E D O M
 KAMIKAZE (bleeding edge, r14432) -------------------
   * 10 oz Vodka       Shake well with ice and strain
   * 10 oz Triple sec  mixture into 10 shot glasses.
   * 10 oz lime juice  Salute!
 ---------------------------------------------------
root@OpenWrt:/#


CategoryModel CategoryBCM63xx

Back to top

oldwiki/openwrtdocs/hardware/usrobotics/9108.txt · Last modified: 2009/04/23 12:38 (external edit)