User Tools

Site Tools


toh:atlantis.land:a02-ra241-w54

Atlantis Land A02-RA241-W54

The Atlantis Land A02-RA241-W54 is an ADSL2+ router with wireless acccess point.

Under Construction!
This page is currently under construction. You can edit the article to help completing it.

Supported Versions

Version/Model Launch Date S/N OpenWrt Version Supported Model Specific Notes
A02-RA241-W54 - - Not supported -

Hardware Highlights

SoC Ram Flash Network USB Serial JTag
TrendChip TC3162P-PQ208G @ :?: MHz 16MiB 4MiB 4 x 1 No Yes ?

Manufacturer's site: http://english.atlantis-land.com/pub/

Hardware

Info

Instruction set: MIPS :?:
Vendor: MediaTek
Bootloader: Bootbase :?:
System-On-Chip: TrendChip TC3162P-PQ208G
CPU @Frq :?:
Flash size: 4 MiB :?:
Flash Chip: Macronix MX29LV320ABTC-90
RAM size: 16 MiB :?:
RAM Chip: SAMSUNG K4S281632F-UC75
Wireless No1: Mini PCI Type III B: Realtek RT2561T :?: Improcomm :?: w/ 2.2 dBi Fixed Antenna for 2.4GHz 802.11b/g
Switch: TrendChip TC3084-TQ64-EPG
Modem: xDSL
USB: No
Serial: Yes
JTAG: :?:

Photos

Front:

FIXME

Back:

FIXME

Opening the case

Note: This will void your warranty!

To remove the cover remove four screws (two of them under the rubber pads).

Main PCB

FIXME

Serial

port.serial general information about the serial port, serial port cable, etc.

The serial headers on the PCB are labelled JK2.

How to connect to the Serial Port of this specific device:

FIXME

Pin Signal
1 VCC
2 TxD
3 RxD
4 GND

Configure terminal with: baud rate 115200 and 8N1 (8 bits, No parity bit, 1 stop bit)

Serial connection parameters:

Bits per second 115200
Data bits 8
Parity None
Stop bits 1
Flow control None

OEM bootlog

INSERT BOOTLOG HERE


Notes

syslog from OEM web interface:

Jan  1 00:00:05 syslog: TC3162 PCI interface initialize
Jan  1 00:00:05 syslog: Initializing RT netlink socket
Jan  1 00:00:05 syslog: wdt_init ..
Jan  1 00:00:05 syslog: TC3162 wtachdog initialize at Interrupt 9
Jan  1 00:00:05 syslog: ADSL DMT initialization starting
Jan  1 00:00:05 syslog: Begin AdslTaskInit.....
Jan  1 00:00:05 syslog: End AdslTaskInit
Jan  1 00:00:05 syslog: Begin to  request IRQ 19
Jan  1 00:00:05 syslog: DMT:Succeed to request IRQ 19
Jan  1 00:00:05 syslog: Initializing ADSL F/W 3.3.2.6 ......
Jan  1 00:00:05 syslog: Initializing ADSL F/W ........ done ^M
Jan  1 00:00:05 syslog: init ADSL status timer
Jan  1 00:00:05 syslog: Ethernet driver for TC3162 version 1.1 on eth0 (IRQ: 21)Initialize Descriptors
Jan  1 00:00:05 syslog: ^Mbil_eth0: driver installation completed.
Jan  1 00:00:05 syslog: TSARM: TC3162 ATM SAR driver 1.4.1 init
Jan  1 00:00:05 syslog: TSARM: TC3162 ATM SAR driver 1.4.1 done
Jan  1 00:00:05 syslog: bi_klength = 1015493
Jan  1 00:00:05 syslog: bi_fs boundary sector[25] address = 0xbfd20000
Jan  1 00:00:05 syslog: bi_ap size = 0x00100000(1048576)
Jan  1 00:00:05 syslog: TC3162 nor-flash: Probing for AMD compatible flash...
Jan  1 00:00:05 syslog: TC3162 nor-flash: Found 1 x 4MiB MXIC MX29LV320AB at 0x0
Jan  1 00:00:05 syslog: create 6 flash partitions
Jan  1 00:00:05 syslog: IP: routing cache hash table of 512 buckets, 4Kbytes
Jan  1 00:00:05 syslog: TCP: Hash tables configured (established 1024 bind 2048)
Jan  1 00:00:05 syslog: IP multicast router 0.06 plus PIM-SM
Jan  1 00:00:05 syslog: **********************************************
Jan  1 00:00:05 syslog: RT61AP Wireless Driver version-1.0.1.0
Jan  1 00:00:06 syslog: device eth0 entered promiscuous mode
Jan  1 00:00:07 syslog: eth0: starting interface.
Jan  1 00:00:07 syslog: br0: port 1(eth0) entering learning state
Jan  1 00:00:07 syslog: br0: port 1(eth0) entering forwarding state
Jan  1 00:00:07 syslog: br0: topology change detected, propagating
Jan  1 00:00:09 syslog: Do emac_hw_init
Jan  1 00:00:09 syslog: Initialize Descriptors
Jan  1 00:00:09 syslog: ^Meth0: re-configure link (1000).
Jan  1 00:00:09 syslog: ADSL1_MULTI^M
Jan  1 00:00:11 syslog: ANNEXA^M
Jan  1 00:00:11 syslog: Open Loop Detect Disable ^M
Jan  1 00:00:11 syslog: offset = 768/512    0/512 ^M
Jan  1 00:00:11 syslog: ave snrm cnt = 1^M
Jan  1 00:00:11 syslog: EC OFF!!^M
Jan  1 00:00:24 PPPoA[70]: ppppa module started
Jan  1 00:00:24 syslog: atm init aal5
Jan  1 00:00:25 DNS RELAY: start.
Jan  1 00:00:48 syslog: atm init aal5
Jan  1 00:01:12 syslog: atm init aal5
Jan  1 00:01:36 syslog: atm init aal5
Jan  1 00:02:00 syslog: atm init aal5
Jan  1 00:02:08 DHCP SERVER: DHCP request from 90:e6:ba:9f:44:f0
Jan  1 00:02:08 DHCP SERVER: DHCPNAK on 192.168.0.9 to 90:e6:ba:9f:44:f0 via br0
Jan  1 00:02:08 DHCP SERVER: DHCPDISCOVER from 90:e6:ba:9f:44:f0 via br0
Jan  1 00:02:09 DHCP SERVER: DHCP offer to 90:e6:ba:9f:44:f0
Jan  1 00:02:09 DHCP SERVER: DHCP request from 90:e6:ba:9f:44:f0
Jan  1 00:02:09 DHCP SERVER: DHCP ack to 90:e6:ba:9f:44:f0
Jan  1 00:02:24 syslog: atm init aal5
Jan  1 00:02:48 syslog: atm init aal5
Jan  1 00:03:12 syslog: atm init aal5
Jan  1 00:03:36 syslog: atm init aal5
Jan  1 00:04:00 syslog: atm init aal5
Jan  1 00:04:09 PPPoA[70]: Exit.
Jan  1 00:04:42 syslog: device ra0 entered promiscuous mode
Jan  1 00:04:42 syslog: br0: port 2(ra0) entering learning state
Jan  1 00:04:42 syslog: br0: port 2(ra0) entering forwarding state
Jan  1 00:04:42 syslog: br0: topology change detected, propagating

Tags

toh/atlantis.land/a02-ra241-w54.txt · Last modified: 2015/12/12 07:30 by tmomas