User Tools

Site Tools


toh:bt:homehub_v5a
This wiki is read only and for archival purposes only. >>>>>>>>>> Please use the new OpenWrt wiki at https://openwrt.org/ <<<<<<<<<<

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
toh:bt:homehub_v5a [2018/02/10 15:41]
heafield multiline code
toh:bt:homehub_v5a [2018/02/10 15:55] (current)
heafield [Installation over serial] make code literals explicit.
Line 97: Line 97:
 <​code>​picocom -b 115200 /​dev/​ttyUSB0</​code>​**NEW:​** In picocom, press <​**Ctrl-a**>​ <​**Ctrl-s**>​ and enter the full path to the ''​lede-lantiq-bthomehubv5a_ram-u-boot.asc''​ to send the bootcode. <​code>​picocom -b 115200 /​dev/​ttyUSB0</​code>​**NEW:​** In picocom, press <​**Ctrl-a**>​ <​**Ctrl-s**>​ and enter the full path to the ''​lede-lantiq-bthomehubv5a_ram-u-boot.asc''​ to send the bootcode.
  
-Alternatively,​ open another terminal and execute the following command to send the bootcode <​code>​cat lede-lantiq-bthomehubv5a_ram-u-boot.asc > /​dev/​ttyUSB0</​code>  ​Now you should see the BTHOMEHUBV5A#​ u-boot prompt+Alternatively,​ open another terminal and execute the following command to send the bootcode <​code>​cat lede-lantiq-bthomehubv5a_ram-u-boot.asc > /​dev/​ttyUSB0</​code> ​ Now you should see the ''​BTHOMEHUBV5A#​'' ​u-boot prompt.
  
 Note that operating in this mode is **atypically slow**. ​ The CPU clock (normally 500MHz) and buses (normally 250MHz) are running at 125MHz for some reason, but the installed system will run at full speed. Note that operating in this mode is **atypically slow**. ​ The CPU clock (normally 500MHz) and buses (normally 250MHz) are running at 125MHz for some reason, but the installed system will run at full speed.
toh/bt/homehub_v5a.txt · Last modified: 2018/02/10 15:55 by heafield