User Tools

Site Tools


toh:buffalo:whr-g300n

Table of Contents

Buffalo WHR-G300N

Version SoC Flash RAM Network Antennas Wireless USB Serial Jtag
1 Ralink 3052_MP2 @384Mhz 4MB 32MB 1+4 x100 2 internal 2.4Ghz bgn no yes yes (untested, needs pullups)

Sometimes is labeled as "WHR-G300N-R"

Serial

JP1 (unpopulated 4 pin connector), located near the "AOSS" button on the top of the case. Pin 1 is the pin with the square pad, towards the edge of the board with LEDs on it.

Pin 1 Pin 2 Pin 3 Pin 4
3.3V TX RX GND

TFTP

When powered with the reset button held down, it attempts to download "firmware.ram" from a TFTP server at 192.168.11.2 and sets its IP to 192.168.11.1. Timeout is set to "10". After a timeout, the router continues to boot linux. If the reset button continues to be held down, the device resets once the busybox "press enter for prompt" is displayed.

Tags

toh/buffalo/whr-g300n.txt · Last modified: 2014/03/19 00:35 (external edit)