User Tools

Site Tools


toh:compex:mmc543ahv

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
toh:compex:mmc543ahv [2013/03/13 08:08]
127.0.0.1 external edit
toh:compex:mmc543ahv [2016/02/25 10:53] (current)
dangh [Hardware info]
Line 4: Line 4:
  
 ===== Hardware info ===== ===== Hardware info =====
-| **Architecture:** | MIPS | +Architecture | MIPS | 
-| **Vendor:** | Atheros | +Vendor | Atheros | 
-| **Bootloader:** | CFE | +Bootloader | CFE | 
-| **System-On-Chip:** | AR7161 | +System-On-Chip | AR7161 | 
-| **CPU Speed:** 680Mhz ​+CPU Speed | 680 Mhz 
-| **Flash size:** | 8 MB (up to 16MB)| +Flash size | 8 MB (up to 16 MB)| 
-| **RAM:** | 32 MB (Max 64MB) DDR SDRAM | +RAM | 32 MB (Max 64 MB) DDR SDRAM | 
-| **Wireless:** | 2 MiniPCI slots , support all Compex MiniPCI cards | +Wireless | 2 × MiniPCI slots , support all Compex MiniPCI cards | 
-| **Ethernet:** | 1 10/100 Base-TX Ethernet Port (with Auto MDI/MDIX) | +Ethernet | 1 × 10/100 Base-TX Ethernet Port (with Auto MDI/MDIX) | 
-| **USB:** | 2 USB 2.0 ports (Optional) | +USB | 2 × USB 2.0 ports (optional) | 
-| **Serial:** | yes | +Serial | yes | 
-| **JTAG:** | yes |+JTAG | yes |
  
 ===== Installation ===== ===== Installation =====
Line 31: Line 31:
 ==== TFTP installation notes ==== ==== TFTP installation notes ====
  
-Set your ethernet interface into static mode (IP address 192.168.168.10,​ netmask 255.255.255.0,​ default gateway 192.168.168.1),​ put your router into **[[toh:​compex:​wp543ahv#restore.mode|Restore mode]]** and upload the firmware by TFTP using the following commands (replace XXXXXX with wp543):+Set your ethernet interface into static mode (IP address 192.168.168.10,​ netmask 255.255.255.0,​ default gateway 192.168.168.1),​ put your router into **[[toh:​compex:​mmc543ahv#restore_mode|Restore mode]]** and upload the firmware by TFTP using the following commands (replace XXXXXX with wp543):
  
 <​code>​ <​code>​
Line 42: Line 42:
 Diagnostic LED will now stop blinking for a while; if the flashing procedure is successfully done, it will start blinking slowly. Now reboot your router manually (turn off - turn on) and OpenWrt will boot.  Diagnostic LED will now stop blinking for a while; if the flashing procedure is successfully done, it will start blinking slowly. Now reboot your router manually (turn off - turn on) and OpenWrt will boot. 
  
-===== Upgrading ​OpenWRT(on compex ​Myloader) =====+===== Upgrading ​OpenWrt (on Compex ​Myloader=====
  
-== Minimum Requirement ==+=== Minimum Requirement ​===
   - Compex loader version 2.54 or above.   - Compex loader version 2.54 or above.
   - OpenWRT will only be supported on WP543 with 4MB NOR flash and above.   - OpenWRT will only be supported on WP543 with 4MB NOR flash and above.
Line 50: Line 50:
   - If there is a USB NAND flash available on board, you would need to change the loader configuration. Please refer to “what to do if there is a onboard NAND Flash”.   - If there is a USB NAND flash available on board, you would need to change the loader configuration. Please refer to “what to do if there is a onboard NAND Flash”.
  
-== Compiling ​OpenWRT ​suitable for use on WP543 ==+=== Compiling ​OpenWrt ​suitable for use on WP543 ==
 +  - Getting source codes<​code bash> 
 +$ svn co -r 12448 https://​snv.openwrt.org/​openwrt/​trunk 
 +</​code>​ 
 +  - Apply patches from the files mod-wp543.tgz (<​del>​[[http://​www.cpx.cz/​dls/​WP543_routerboard/​|resource url]]</​del>​)<​code bash> 
 +$ tar -zxvf mod-wp543.tgz 
 +$ cp -a mod-wp543/* trunk/ 
 +</​code>​ 
 +  - Compile<​code bash> 
 +$ cd trunk 
 +$ cp wp543.config .config 
 +$ make 
 +</​code>​ 
 +OpenWrt Firmware will be in //​bin/​openwrt-ar71xx-wp543.bin//​
  
-1. Getting source codes +=== Uploading the OpenWrt ​firmware to WP543 running MyLoader v2.54.0717 ​===
-  svn co –r 12448 https://​snv.openwrt.org/​openwrt/​trunk +
- +
-2. Apply patches from the files mod-wp543.tgz ([[http://​www.cpx.cz/​dls/​WP543_routerboard/​|resource url]]) +
-  tar zxvf mod-wp543.tgz +
-  cp –a mod-wp543/* trunk/ +
- +
-3. Compile +
-  cd trunk +
-  cp wp543.config .config +
-  make +
- +
-OpenWRT Firmware will be in bin/​openwrt-ar71xx-wp543.bin +
- +
-== Uploading the OpenWRT ​firmware to WP543 running MyLoader v2.54.0717 ==+
  
 a. Via Compex Firmware a. Via Compex Firmware
- 
   *Put the AP in Firmware Upgrade mode and upload the file.   *Put the AP in Firmware Upgrade mode and upload the file.
   *This file is for WP543 with 4MB or 8MB NOR flash.   *This file is for WP543 with 4MB or 8MB NOR flash.
 b. Via TFTP b. Via TFTP
   *Go to the firmware upgrade mode (By pressing and hold the Reset button and plug-in the power adapter).   *Go to the firmware upgrade mode (By pressing and hold the Reset button and plug-in the power adapter).
-  *Upload the OpenWRT ​image to the device (tftp i 192.168.168.1 put openwrt-ar71xx-wp543.bin)+  *Upload the OpenWrt ​image to the device (//$// **tftp -i 192.168.168.1 put openwrt-ar71xx-wp543.bin**)
  
 ===== Wireless ===== ===== Wireless =====
Line 86: Line 84:
 This page has been assembled from a number of different pages from the old wiki and the current wiki. Refer to them for more (possibly outdated) information. This page has been assembled from a number of different pages from the old wiki and the current wiki. Refer to them for more (possibly outdated) information.
  
-  *[[http://​www.compex.com.sg/​forum/​|Compex forum]] ​\\ +  *<del>[[http://​www.compex.com.sg/​forum/​|Compex forum]]</​del>​ 
-  *[[http://​cpx.px.cz/​|Another Compex forum (CZ/ENG)]]+  *<del>[[http://​cpx.px.cz/​|Another Compex forum (CZ/ENG)]]</​del>​
  
 +===== Tags =====
 +[[meta:​tags|How to add tags]]
 +{{tag>​AR7161}}
toh/compex/mmc543ahv.1363158511.txt.bz2 · Last modified: 2016/02/02 20:23 (external edit)