User Tools

Site Tools


toh:comtrend:ar5387un

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Previous revision
toh:comtrend:ar5387un [2012/09/07 21:00]
toh:comtrend:ar5387un [2014/10/04 11:03] (current)
viric
Line 1: Line 1:
 ====== Comtrend AR-5387un ====== ====== Comtrend AR-5387un ======
-**<color red>The AR-5387un is currently not supported!.</color>​** +Supported since Barrier Breaker [[https://​dev.openwrt.org/changeset/​33894|R33894]].
  
  
  
 ===== Installation ===== ===== Installation =====
 +
 +Barrier Breaker runs fine, but the wifi is not supported (linux 3.10): [[https://​downloads.openwrt.org/​barrier_breaker/​14.07/​brcm63xx/​generic/​openwrt-AR-5387un-squashfs-cfe.bin|openwrt-AR-5387un-squashfs-cfe.bin (BB)]]
 +
 +Trunk code (CC) has the wifi supported (linux 3.14): [[https://​downloads.openwrt.org/​snapshots/​trunk/​brcm63xx/​openwrt-AR-5387un-squashfs-cfe.bin|openwrt-AR-5387un-squashfs-cfe.bin (CC)]]
 +
 ==== Flashing ANY Firmware ==== ==== Flashing ANY Firmware ====
 You must set your TCP/IP v4 protocol to: You must set your TCP/IP v4 protocol to:
Line 26: Line 30:
 | **Vendor:​** ​         | [[wp>​Broadcom]] | | **Vendor:​** ​         | [[wp>​Broadcom]] |
 | **[[doc:​techref:​Bootloader]]:​** ​    | [[doc:​techref:​bootloader:​CFE]] | | **[[doc:​techref:​Bootloader]]:​** ​    | [[doc:​techref:​bootloader:​CFE]] |
-Bootloader version ​1.0.37-110.11 ​|+**Board ID:**      ​96328A-1441N1  ​|
 | **[[doc:​hardware:​soc|System-On-Chip]]:​** ​ | Broadcom BCM6328 | | **[[doc:​hardware:​soc|System-On-Chip]]:​** ​ | Broadcom BCM6328 |
 | **[[doc:​hardware:​cpu|CPU]]/​Speed** ​       | BMIPS4350 / 320 MHz | | **[[doc:​hardware:​cpu|CPU]]/​Speed** ​       | BMIPS4350 / 320 MHz |
-| **Board ID:**      | 96328A-1441N1 ​ | 
 | **Flash-Chip:​** ​     | MX25L128 | | **Flash-Chip:​** ​     | MX25L128 |
-| Flash size | 16 MiB | +**Flash size** | 16 MiB | 
-| RAM | 64 MiB | +**RAM-Chip** | ProMOS V59C1512164QDJ25 / DDR2-800 | 
-| Wireless | BCM43225 (14e4:a8d8) 802.11b/g/n | +| **RAM size** ​| 64 MiB | 
-Wireless power ? mW |+**Wireless** | BCM43225 (14e4:a8d8) 802.11b/g/n | 
 +**Antenna** ​2x |
 | **Ethernet:​** ​       | Internal BRCM6328 Switch | | **Ethernet:​** ​       | Internal BRCM6328 Switch |
-| USB | yes +**USB** | yes |
-| Power adapter | ? | +
-| Power margin | ? | +
-| Antenna | 2x | +
-| Antenna gain | ? dBi |+
 | **[[doc:​hardware:​port.serial|Serial]]:​** ​         | [[#​Serial|Yes]] | | **[[doc:​hardware:​port.serial|Serial]]:​** ​         | [[#​Serial|Yes]] |
 | **[[doc:​hardware:​port.jtag|JTAG]]:​** ​           | [[#​JTAG|?​]] ​ | | **[[doc:​hardware:​port.jtag|JTAG]]:​** ​           | [[#​JTAG|?​]] ​ |
  
 ==== Photos ==== ==== Photos ====
-=== Router ​===+=== Casing ​===
 {{:​toh:​comtrend:​ar5387un.jpg}} {{:​toh:​comtrend:​ar5387un.jpg}}
 +=== Board === 
 +{{:​media:​ar-5387un_board_t.jpg?​500|}}
 ==== JTAG ==== ==== JTAG ====
 -> [[doc:​hardware:​port.jtag]] general information about the JTAG port, JTAG cable, etc. -> [[doc:​hardware:​port.jtag]] general information about the JTAG port, JTAG cable, etc.
Line 58: Line 59:
 How to connect to the Serial Port of this specific device: How to connect to the Serial Port of this specific device:
  
-{{:​toh:​comtrend:​ar5387un_serial.jpg}}+{{:​toh:​comtrend:​ar5387un_serial.jpg?500x300|}}
  
 **Photo of PCB with markings** **Photo of PCB with markings**
Line 66: Line 67:
 Read: [[doc:​uci:​system#​leds|System configuration:​ Leds]] to configure the leds Read: [[doc:​uci:​system#​leds|System configuration:​ Leds]] to configure the leds
 ^ Pin ^ Event ^ Active ^ ^ Pin ^ Event ^ Active ^
-power | High | +inet (red) | High | 
-alarm | High | +power (red) | High | 
-| inet | High |+| inet (green) ​| High 
 +| 8 | power (green) | High | 
 +| 11 | dsl (green) | Low |
  
 ==== Buttons ==== ==== Buttons ====
 -> [[doc:​howto:​hardware.button]] on howto use and configure the hardware button(s). -> [[doc:​howto:​hardware.button]] on howto use and configure the hardware button(s).
 ^ Pin ^ Event ^ Active ^ ^ Pin ^ Event ^ Active ^
-Wifi | Low | +23 reset | Low | 
-| ? | Reset | Low | +
-| ? | WPS | Low |+
  
 ===== Bootlogs ===== ===== Bootlogs =====
Line 348: Line 350:
 </p> </p>
 </​HTML>​ </​HTML>​
-==== Openwrt Bootlog ​====+==== OpenWrt ​====
 <​HTML>​ <​HTML>​
 <p style="​padding:​ 10px;​border:​1px solid grey;​height:​600px;​font:​10px/​14px Georgia, Garamond, Serif;​overflow:​Auto;​background-color:#​FFFFFF">​ <p style="​padding:​ 10px;​border:​1px solid grey;​height:​600px;​font:​10px/​14px Georgia, Garamond, Serif;​overflow:​Auto;​background-color:#​FFFFFF">​
Line 541: Line 543:
 </​HTML>​ </​HTML>​
  
-===== Hardware Mods ===== + 
-N/A+ 
 +===== Tags ===== 
 +{{tag>​bcm63xx bcm6328}}
toh/comtrend/ar5387un.1347044425.txt.bz2 · Last modified: 2012/09/07 21:00 (external edit)