Differences
This shows you the differences between two versions of the page.
|
toh:d-link:dir-620 [2012/11/08 18:11] 123serge123 |
toh:d-link:dir-620 [2013/05/05 05:08] (current) 123serge123 |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| ^ Version/Model ^ Launch Date ^ S/N ^ OpenWrt Version Supported ^ Model Specific Notes ^ | ^ Version/Model ^ Launch Date ^ S/N ^ OpenWrt Version Supported ^ Model Specific Notes ^ | ||
| | A1 | - | - | [[https://dev.openwrt.org/changeset/33143/trunk|r33143]] | - | | | A1 | - | - | [[https://dev.openwrt.org/changeset/33143/trunk|r33143]] | - | | ||
| - | | D1 | - | - | WIP | - | | + | | D1 | - | - | [[http://pastebin.com/yhhiGxaD|patch for AA]] [[https://dev.openwrt.org/changeset/36432/trunk|r36432]]| - | |
| ===== Hardware Highlights ===== | ===== Hardware Highlights ===== | ||
| Line 25: | Line 25: | ||
| OEM firmware web-interface accept the U-Boot images targetted for ''DIR_620D1''. | OEM firmware web-interface accept the U-Boot images targetted for ''DIR_620D1''. | ||
| + | |||
| + | Be careful with the patch above. I accidentally downloaded and applied it with dos line endings, and that resulted in kernel panic: | ||
| + | |||
| + | ''/etc/preinit: /lib/preinit/06_set_iface_mac: line 10: syntax error: unexpected word (expecting "in")'' | ||
| + | |||
| + | To debrick, hold button for while connecting power. Release button after ~30 sc, http firmware loader should be available at 192.168.0.1 | ||
| + | |||
| + | ''starting httpd to update firmware... | ||
| + | |||
| + | NetTxPacket = 0x81FE5A00 | ||
| + | |||
| + | KSEG1ADDR(NetTxPacket) = 0xA1FE5A00 | ||
| + | |||
| + | NetLoop,call eth_halt ! | ||
| + | Trying Eth0 (10/100-M) | ||
| + | |||
| + | Waitting for RX_DMA_BUSY status Start... done | ||
| + | |||
| + | |||
| + | Header Payload scatter function is Disable !! | ||
| + | |||
| + | ETH_STATE_ACTIVE!! | ||
| + | Starting Httpd Server From Server 192.168.0.1 | ||
| + | Our Netmask 255.255.255.0'' | ||
| ==== Flash Layout ==== | ==== Flash Layout ==== | ||
| Line 41: | Line 65: | ||
| ==== Led config ==== | ==== Led config ==== | ||
| -> [[doc:uci:system#leds]] | -> [[doc:uci:system#leds]] | ||
| + | Rev A1 | ||
| + | |||
| Please note that the "WAN" led will be inactive unless there's a link on the "WAN" port present, that's a hardware limitation. | Please note that the "WAN" led will be inactive unless there's a link on the "WAN" port present, that's a hardware limitation. | ||
| + | |||
| + | Rev D1 | ||
| + | |||
| + | Last vendor firmware v1.3.10 help to find wifi LED gpio17 (need JTAG to GPIO mode switch). So [[http://pastebin.com/yhhiGxaD|this patch]] add full support for OpenWrt Attitude Adjustment. And [[http://pastebin.com/HgWkmzBy|new patch]] (new version of [[http://pastebin.com/yntTTCSU|patch]] with corrected flash size) for current trunk (devicetree file included) | ||
| ===== Hardware ===== | ===== Hardware ===== | ||
toh/d-link/dir-620.1352394717.txt.bz2 · Last modified: 2012/11/08 18:11 by 123serge123