| Version/Model || Launch Date || S/N || OpenWrt Version Supported || Model Specific Notes
| A2 || 2005-04 || - || 10.03 || -
NOTE: Anything not included in model specific notes, or where a short comment couldn't be included on the notes.
Please check out the article Flash.Layout. It contains an example and a couple of explanations.
OEM easy installation
Note: Reset storage adapter to factory defaults if it has been previously configured.
If you have already installed OpenWrt and like to reflash for e.g. upgrading to a new OpenWrt version you can upgrade using the mtd command line tool. It is important that you put the firmware image into the ramdisk (/tmp) before you start flashing.
LuCI Web Upgrade Process
Terminal Upgrade Process
mtd write /tmp/xxx.abc linux && reboot
→ Basic configuration After flashing, proceed with this.
Set up your Internet connection, configure wireless, configure USB port, etc.
→ port.serial general information about the serial port, serial port cable, etc.
How to connect to the Serial Port of this specific device:
(3.3) (TxD) (RxD) (GND)
—> Screw + Board RSide edge