User Tools

Site Tools


toh:engenius:esr-6650

Senao/Engenius ESR-6650

Built by Senao Networks, this router is made to serve as a 3G gateway. It is sold under many names, including Engenius ESR-6650 and Encore ENHWI-3GN3.

Hardware Highlights

Rev CPU Ram Flash WiFi Network USB Serial JTag
1.10 Ralink RT3052@384MHz 32MiB (Etrontech EM63A165TS-6G) 4MiB (Macronix 29LV320DTTI-70G 1x1 2.4Ghz 802.11b/g/n 2x 10/100MiBit/s 1x 2.0 Yes ?

Board Pictures

Serial Port

57600 baud, 8n1

o 3.3v
o GND
o TX
o RX

Bootlog

OpenWRT Bootlog (Barrier Breaker rc1 (r41580))

U-boot Ver:1.0.1.1 2009/09/25 Board: Ralink APSoC DRAM: 32 MB 1*32 MB ============================================ ASIC 3052_MP2 (Port5<->None) Product Name: ESR-6650 SDRAM CAS = 3(d1835272) ============================================ Please choose the operation: 1: Load system code to SDRAM via TFTP. [ 0.000000] Linux version 3.10.44 (bb@builder1) (gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.04 r41580) ) #2 Sat Jul 12 19:13:26 CEST 2014 [ 0.000000] SoC Type: Ralink RT3350 id:1 rev:2 [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU revision is: 0001964c (MIPS 24KEc) [ 0.000000] MIPS: machine is Senao / EnGenius ESR-9753 [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 02000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Zone ranges: [ 0.000000] Normal [mem 0x00000000-0x01ffffff] [ 0.000000] Movable zone start for each node [ 0.000000] Early memory node ranges [ 0.000000] node 0: [mem 0x00000000-0x01ffffff] [ 0.000000] Primary instruction cache 32kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 32 bytes [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 [ 0.000000] Kernel command line: console=ttyS0,57600 rootfstype=squashfs,jffs2 [ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes) [ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) [ 0.000000] Writing ErrCtl register=00058d00 [ 0.000000] Readback ErrCtl register=00058d00 [ 0.000000] Memory: 29160k/32768k available (2282k kernel code, 3608k reserved, 567k data, 220k init, 0k highmem) [ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS:256 [ 0.000000] CPU Clock: 320MHz [ 0.000000] Calibrating delay loop... 212.58 BogoMIPS (lpj=1062912) [ 0.080000] pid_max: default: 32768 minimum: 301 [ 0.080000] Mount-cache hash table entries: 512 [ 0.090000] pinctrl core: initialized pinctrl subsystem [ 0.100000] NET: Registered protocol family 16 [ 0.150000] bio: create slab <bio-0> at 0 [ 0.160000] rt2880_gpio 10000600.gpio: registering 24 gpios [ 0.170000] rt2880_gpio 10000600.gpio: registering 24 irq handlers [ 0.180000] Switching to clocksource MIPS [ 0.190000] NET: Registered protocol family 2 [ 0.200000] TCP established hash table entries: 512 (order: 0, 4096 bytes) [ 0.220000] TCP bind hash table entries: 512 (order: -1, 2048 bytes) [ 0.230000] TCP: Hash tables configured (established 512 bind 512) [ 0.240000] TCP: reno registered [ 0.250000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.260000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.270000] NET: Registered protocol family 1 [ 0.280000] rt-timer 10000100.timer: maximum frequncy is 6510Hz [ 0.340000] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.350000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 0.380000] msgmni has been set to 56 [ 0.380000] io scheduler noop registered [ 0.390000] io scheduler deadline registered (default) [ 0.410000] Serial: 8250/16550 driver, 16 ports, IRQ sharing enabled [ 0.440000] 10000c00.uartlite: ttyS0 at MMIO 0x10000c00 (irq = 20) is a 16550A [ 0.450000] console [ttyS0] enabled, bootconsole disabled [ 0.450000] console [ttyS0] enabled, bootconsole disabled [ 0.480000] 1f000000.cfi: Found 1 x16 devices at 0x0 in 16-bit bank. Manufacturer ID 0x0000c2 Chip ID 0x0022a7 [ 0.500000] Amd/Fujitsu Extended Query Table at 0x0040 [ 0.510000] Amd/Fujitsu Extended Query version 1.1. [ 0.520000] 1f000000.cfi: Swapping erase regions for top-boot CFI table. [ 0.530000] number of CFI chips: 1 [ 0.540000] 4 ofpart partitions found on MTD device 1f000000.cfi [ 0.550000] Creating 4 MTD partitions on "1f000000.cfi": [ 0.570000] 0x000000000000-0x000000030000 : "u-boot" [ 0.580000] 0x000000030000-0x000000040000 : "u-boot-env" [ 0.590000] 0x000000040000-0x000000050000 : "factory" [ 0.610000] 0x000000050000-0x000000400000 : "firmware" [ 0.620000] 0x00000014e22b-0x000000400000 : "rootfs" [ 0.630000] mtd: partition "rootfs" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only [ 0.660000] mtd: device 4 (rootfs) set to be root filesystem [ 0.670000] mtd: partition "rootfs_data" created automatically, ofs=0x370000, len=0x90000 [ 0.690000] 0x000000370000-0x000000400000 : "rootfs_data" [ 0.720000] eth0: done loading [ 0.730000] rt2880_wdt 10000120.watchdog: Initialized [ 0.740000] TCP: cubic registered [ 0.750000] NET: Registered protocol family 17 [ 0.760000] Bridge firewalling registered [ 0.770000] 8021q: 802.1Q VLAN Support v1.8 [ 0.790000] VFS: Mounted root (squashfs filesystem) readonly on device 31:4. [ 0.800000] Freeing unused kernel memory: 220K (802c9000 - 80300000) procd: Console is alive procd: - watchdog - [ 3.760000] usbcore: registered new interface driver usbfs [ 3.770000] usbcore: registered new interface driver hub [ 3.790000] usbcore: registered new device driver usb [ 3.810000] dwc_otg: version 2.72a 24-JUN-2008 [ 3.830000] leds-gpio gpio-leds.3: pins are not configured from the driver procd: - preinit - Press the [f] key and hit [enter] to enter failsafe mode Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level jffs2 is ready jffs2 is ready [ 8.380000] jffs2: notice: (291) jffs2_build_xattr_subsystem: complete building xattr subsystem, 19 of xdatum (1 unchecked, 18 orphan) and 237 of xref (0 dead, 18 orphan) found. switching to overlay procd: - early - procd: - watchdog - procd: - ubus - procd: - init - Please press Enter to activate this console. [ 10.870000] NET: Registered protocol family 10 [ 10.900000] nf_conntrack version 0.5.0 (459 buckets, 1836 max) [ 10.920000] ip6_tables: (C) 2000-2006 Netfilter Core Team [ 10.950000] Loading modules backported from Linux version master-2014-05-22-0-gf2032ea [ 10.970000] Backport generated by backports.git backports-20140320-37-g5c33da0 [ 10.990000] ip_tables: (C) 2000-2006 Netfilter Core Team [ 11.080000] xt_time: kernel timezone is -0000 [ 11.190000] cfg80211: Calling CRDA to update world regulatory domain [ 11.210000] cfg80211: World regulatory domain updated: [ 11.220000] cfg80211: DFS Master region: unset [ 11.230000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp), (dfs_cac_time) [ 11.250000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A, 2000 mBm), (N/A) [ 11.270000] cfg80211: (2457000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm), (N/A) [ 11.280000] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (N/A, 2000 mBm), (N/A) [ 11.300000] cfg80211: (5170000 KHz - 5250000 KHz @ 160000 KHz), (N/A, 2000 mBm), (N/A) [ 11.310000] cfg80211: (5250000 KHz - 5330000 KHz @ 160000 KHz), (N/A, 2000 mBm), (0 s) [ 11.330000] cfg80211: (5490000 KHz - 5730000 KHz @ 160000 KHz), (N/A, 2000 mBm), (0 s) [ 11.350000] cfg80211: (5735000 KHz - 5835000 KHz @ 80000 KHz), (N/A, 2000 mBm), (N/A) [ 11.360000] cfg80211: (57240000 KHz - 63720000 KHz @ 2160000 KHz), (N/A, 0 mBm), (N/A) [ 11.400000] PPP generic driver version 2.4.2 [ 11.430000] NET: Registered protocol family 24 [ 11.510000] rt2800_wmac 10180000.wmac: failed to load eeprom property [ 11.520000] ieee80211 phy0: rt2x00lib_request_eeprom_file: Info - Loading EEPROM data from 'soc_wmac.eeprom'. [ 11.550000] ieee80211 phy0: rt2x00_set_rt: Info - RT chipset 2872, rev 0200 detected [ 11.560000] ieee80211 phy0: rt2x00_set_rf: Info - RF chipset 0005 detected [ 20.740000] device eth0.1 entered promiscuous mode [ 20.750000] device eth0 entered promiscuous mode [ 20.770000] br-lan: port 1(eth0.1) entered forwarding state [ 20.780000] br-lan: port 1(eth0.1) entered forwarding state [ 22.780000] br-lan: port 1(eth0.1) entered forwarding state procd: - init complete - BusyBox v1.22.1 (2014-07-11 15:16:08 CEST) built-in shell (ash) Enter 'help' for a list of built-in commands. _______ ________ __ | |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D O M ----------------------------------------------------- BARRIER BREAKER (14.07-rc1, r41580) ----------------------------------------------------- * 1/2 oz Galliano Pour all ingredients into * 4 oz cold Coffee an irish coffee mug filled * 1 1/2 oz Dark Rum with crushed ice. Stir. * 2 tsp. Creme de Cacao ----------------------------------------------------- root@OpenWrt:/#


Notes

Tags

toh/engenius/esr-6650.txt · Last modified: 2015/12/14 19:51 by tmomas