User Tools

Site Tools


toh:linksys:e1000

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
toh:linksys:e1000 [2012/12/14 03:47]
hhm
toh:linksys:e1000 [2014/02/24 09:13] (current)
hhm
Line 2: Line 2:
  
 ^ Version/​Model ^ CPU ^ RAM ^ Flash ^ Network ^ USB ^ Serial ^ JTAG ^ Bootloader ^ OpenWrt Version Supported ^  ^ Version/​Model ^ CPU ^ RAM ^ Flash ^ Network ^ USB ^ Serial ^ JTAG ^ Bootloader ^ OpenWrt Version Supported ^ 
-| v1   ​| ​ Broadcom 47162@300MHz | 32MB | 4MB | 4x1 | No | Yes | ? | CFE | Trunk (WIP) |+| v1   ​| ​ Broadcom 47162@300MHz | 32MB | 4MB | 4x1 | No | Yes | ? | CFE | Barrier Breaker trunk (WIP[[#​fine.print|*]]) |
 | v2   | | v2   |
 +== Fine print ==
 +  * At time of writing this (2013/jan) a firmware image needs to be built from scratch with an option enabled and a patch in order for networking to function properly; see [[https://​forum.openwrt.org/​viewtopic.php?​pid=188754#​p188754|this forum post]] for instructions.
 +  * update (2013/feb) now the wired drivers work out of the box, but enabling wireless currently ​ disables the wired networking until the wireless is disabled once again, so locking oneself out of the wireless can BRICK the device ([[doc:​howto:​generic.failsafe|failsafe]] may work, but I do not know if it is working (yet) on this device)!
 +  * update (2013/jun) see [[https://​forum.openwrt.org/​viewtopic.php?​pid=201025#​p201025|this]] for more info
 +  * update (2013/sep) working, use at your own risk, not enough room on device to install Luci
 +  * update (2014/feb) see [[https://​forum.openwrt.org/​viewtopic.php?​pid=226138#​p226138|this]] for more info
 + 
  
 ===== V1 ===== ===== V1 =====
-An 802.11n router; has same hardware as [[.:​WRT160N|Linksys WRT160Nv3]] and [[..:​cisco:​M10|Cisco Valet M10 v1]].+The first version is an 802.11n router; has same hardware as [[.:​WRT160N|Linksys WRT160Nv3]] and [[..:​cisco:​M10|Cisco Valet M10 v1]].
  
 ==== Installation ==== ==== Installation ====
-Uses the brcm47xx generic .trx firware image.+The version below does not load LuCi, you can still get a DHCP address and SSH in.
  
-TFTP flashing initiated via serial works, "flash -noheader : flash1.trx" ​at CFE prompt.+Do this at YOUR OWN RISK, the current snapshot of trunk may be broken! It may be better to wait until the next stable release.
  
-OEM easy installation:​ Not yet (since wired networking is not yet supported at time of writing thisand wireless is locked by default in the regular builds as far as I know.)+Use the brcm47xx generic .trx firware imageor see if the BIN image works. See details below.
  
-OEM installation using the TFTP methodDoes not work, because of some kind of misconfiguration in the software, use serial-initiated TFTP flashing instead.+The most recent trunk WIP snapshot builds can be found at [[http://downloads.openwrt.org/​snapshots/​trunk/​brcm47xx/​]]
  
 +OEM easy installation (aka via original firmware): Not yet (since the wired networking drivers are not included in the stock firmware builds at time of writing this, and wireless is locked by default in the regular builds as far as I know.)
 +
 +  * Update (2013/feb): The firmware can be flashed by updating to DD-WRT first, and then uploading with the DD-WRT firmware update feature (Reason: The stock firmware currently requires [[doc:​techref:​header|a BIN image, not a TRX]].) See [[#​fine.print|fine print]] for notices.
 +  * Update (2013/sep): There is now a BIN formatted image, to be used for OEM easy installation,​ called "​openwrt-e1000_v1_v2-squashfs.bin"​. However, I am not sure if it works (correctly, or at all).
 +
 +OEM installation using the TFTP method: Does not work, because of some kind of misconfiguration in the bootloader; use serial-initiated TFTP flashing instead (REQUIRES TTL SERIAL ACCESS).
 +
 +TFTP flashing initiated via serial: works; <​code>​flash -noheader : flash1.trx</​code>​ at CFE prompt.
  
 ==== Bootlogs ==== ==== Bootlogs ====
Line 276: Line 291:
  
 ==== More Info ==== ==== More Info ====
-See [[https://​forum.openwrt.org/​viewtopic.php?​pid=179199|this ​page on the forums]] for more information.+See [[https://​forum.openwrt.org/​viewtopic.php?​pid=179199|this ​forum thread]] for more information. 
 + 
 + 
 +===== V2 =====
  
 +===== Etc. =====
 ==== Tags ==== ==== Tags ====
  
-{{tag>​FastEthernet 5Port InternalAntenna 32RAM 8Flash ​MIPS 74Kc 802.11n Serial}}+{{tag>​FastEthernet 5Port InternalAntenna 32RAM 4Flash bcm47xx bcm47162 ​MIPS 74Kc 802.11n Serial}}
toh/linksys/e1000.1355453263.txt.bz2 · Last modified: 2012/12/14 03:47 by hhm