Table of Contents
Netgear WG602v4
Note: This device is not being worked on due to its size of flash memory.
Hardware Highlights
| CPU | Ram | Flash | Network | USB | Serial | JTag |
|---|---|---|---|---|---|---|
| Broadcom BCM5350@200 MHz | 2MiB | 8MiB | 1 x 1 | No | Yes | Yes |
Installation
WIP
Flash Layout
WIP
OEM easy installation
WIP
OEM installation using the TFTP method
WIP
Upgrading OpenWrt
WIP
LuCI Web Upgrade Process
WIP
Terminal Upgrade Process
WIP
Basic configuration
WIP
Specific Configuration
Failsafe mode
Buttons
→ hardware.button on howto use and configure the hardware button(s).
The Linksys WRT54GL has two buttons. They are Reset and Secure Easy Setup. Here, we merely name the buttons, so we can use them in the above Howto:
| BUTTON | Event |
|---|---|
| Reset | reset |
| Secure Easy Setup | ses |
Hardware
Info
| Architecture: | MIPS |
| Vendor: | Broadcam |
| Bootloader: | CFE |
| System-On-Chip: | BCM5354KFBG |
| CPU/Speed | 240MHz |
| Flash-Chip: | M12l64164A (www.esmt.com.tw/DB/manager/upload/M12L64164A.pdf) |
| Flash size: | 2 MiB |
| RAM: | 8 MiB |
| Wireless: | ? |
| Ethernet: | 1x Broadcom BCM47xx 10/100 Mbps Ethernet |
| Internet: | PPPoX DHCP |
| USB: | No |
| Serial: | Yes |
| JTAG: | Yes |
Photos
WG602 v4
Front:
Back:
Photo of back of the casing
Opening the case
Note: This will void your warranty!
- To remove the cover do a/b/c
Main PCB
Photo of PCB
Serial & JTAG
→ port.serial general information about the serial port, serial port cable, etc.
How to connect to the Serial Port of this specific device:
Debricking
Bootloader Mods
- you could read about cfe in general
Hardware mods
- as a beginner, you really should inform yourself about soldering in general and then obtain some practical experience!
128MiB RAM Mod
I²C GPIO Mod
I²C Tiny-USB Mod
Notes
Tags
For some Help with the Tags, please have a look here: tags
toh/netgear/wg602.txt · Last modified: 2013/03/24 15:56 by hauke