Created by Sagemcom to GVT internet service provider.

Please check out the article Flash Layout. It contains an example and a couple of explanations.

Flash layout:

Section 00 Type BOOT Range 0x01000000-0x01020000 MaxSize 0x00020000

No more information.

Section 01 Type FACTORY Range 0x00000000-0x00000000 MaxSize 0xFFFFFF6C

Uninitialized.

Section 02 Type CONF Range 0x01040000-0x01060000 MaxSize 0x0001FF6C

Size 0x00003CEA Name 'rg_conf'

Checksum 0x001E43AB Counter 0x000000BA Start Offset 0x00000000

Section 03 Type CONF Range 0x01060000-0x01080000 MaxSize 0x0001FF6C

Size 0x00003C4C Name 'rg_conf'

Checksum 0x001E4637 Counter 0x000000B9 Start Offset 0x00000000

Section 04 Type RECOVERY Range 0x01080000-0x01B00000 MaxSize 0x00A80000

No more information.

Section 05 Type JFFS Range 0x01B00000-0x02000000 MaxSize 0x00500000

No more information.

Section 06 Type IMAGE Range 0x00000000-0x01000000 MaxSize 0x01000000

No more information.

Total 7 sections found.

→ hardware.button on howto use and configure the hardware button(s).

The Sagemcom F@ST 2764 has 4 buttons. They are Reset and Secure Easy Setup and other 2 unused:

Model Number

Front:

Photo of front of the casing

Back:

Photo of back of the casing

Note: This will void your warranty!

• To remove the cover do a/b/c

Main PCB

IMG-20120824-110251-w.jpg

Photo of PCB

→ port.serial general information about the serial port, serial port cable, etc.

How to connect to the Serial Port of this specific device:

Photo of PCB with markings

→ port.jtag general information about the JTAG port, JTAG cable, etc.

How to connect to the JTAG Port of this specific device:

Photo of PCB with markings

1. you could read about bootloader in general

For some Help with the Tags, please have a look here: tags