300Mbps Wireless N Gigabit Router with USB Port

NOTE: Anything not included in model specific notes, or where a short comment couldn't be included on the notes.

1. → obtain.firmware
2. → Install OpenWrt

Please check out the article Flash Layout. It contains an example and a couple of explanations.

dev: size erasesize name mtd0: 00020000 00010000 "u-boot" mtd1: 00010000 00010000 "Config" mtd2: 00100000 00010000 "vmlinux" mtd3: 002b0000 00010000 "rootfs" mtd4: 00020000 00010000 "ART"

→ generic.sysupgrade

NOTE: some of the following information may not be entirely correct.

Model Number

Front:

Photo of front of the casing

Back:

Photo of back of the casing

Note: This will void your warranty!

To remove the cover, remove the four screws on the bottom. The front ones are under the rubber feet if you have already put them on.

Main PCB

Photo of PCB

→ port.serial general information about the serial port, serial port cable, etc.

How to connect to the Serial Port of this specific device:

There are four contacts in a row right next to the JTAG port. I have it hooked up and working and will add a picture later.

3.3V serial port voltage

COM port settings: Speed:115200, Data bits:8, Stop bits:1, Parity:none, Flow control:none

Photo of PCB with markings

→ port.jtag general information about the JTAG port, JTAG cable, etc.

How to connect to the JTAG Port of this specific device:

There is a 14 pin JTAG port. I haven't tried using it. See the serial port section for a picture as I don't know what the pins are for.

→ generic.debrick

1. you could read about bootloader in general

TEW-634GRU port