User Tools

Site Tools

This wiki is read only and for archival purposes only. >>>>>>>>>> Please use the new OpenWrt wiki at <<<<<<<<<<

US Robotics 9107

Hardware info

ADSL2+ Chip with CPU MIPS32 FLASH 2MB SDRAM 8MB Switch 10/100MBit WLAN 802.11b/g WLAN Front-End ASDL Line driver
Broadcom BCM6348KPBG ST M29W160ET (CFE reports AM29LV160T) EtronTech EM638165TS-7G Broadcom BCM5325EKQMG - - Broadcom BCM6301KSG
datasheet datasheet datasheet

Board images

usr9107_top.jpg usr9107_bottom.jpg

Serial & JTAG port pinout


UART (Header 1x4pin)

1 Tx
2 Rx
3 3.3v

CFE startup output

CFE version 1.0.37-1.5 for BCM96348 (32bit,SP,BE)
Build Date: Fri Jul  1 08:33:19 CDT 2005 (root@localhost.localdomain)
Copyright (C) 2000-2005 Broadcom Corporation.

Boot Address 0xbfc00000

Initializing Arena.
Initializing Devices.
Parallel flash device: name AM29LV160T, id 0x22c4, size 2048KB
CPU type 0x29107: 256MHz, Bus: 128MHz, Ref: 32MHz
Total memory: 8388608 bytes (8MB)

Total memory used by CFE:  0x80401000 - 0x80524F80 (1195904)
Initialized Data:          0x8041C3B0 - 0x8041E710 (9056)
BSS Area:                  0x8041E710 - 0x80422F80 (18544)
Local Heap:                0x80422F80 - 0x80522F80 (1048576)
Stack Area:                0x80522F80 - 0x80524F80 (8192)
Text (code) segment:       0x80401000 - 0x8041C3AC (111532)
Boot area (physical):      0x00525000 - 0x00565000
Relocation Factor:         I:00000000 - D:00000000

Board IP address                  :
Host IP address                   :
Gateway IP address                :
Run from flash/host (f/h)         : f
Default host run file name        : vmlinux
Default host flash file name      : bcm963xx_fs_kernel
Boot delay (0-9 seconds)          : 1
Board Id Name                     : 96348R-A
Psi size in KB                    : 24
Number of MAC Addresses (1-32)    : 11
Base MAC Address                  : 00:14:c1:11:3c:2b
Ethernet PHY Type                 : External Switch Using Reverse MII
Memory size in MB                 : 8
Country code                      : ALL

*** Press any key to stop auto run (1 seconds) ***

OpenWRT boot log

Auto run second count down: 0 Code Address: 0x80010000, Entry Address: 0x80010000 Decompression OK! Entry at 0x80010000 Closing network. Starting program at 0x80010000 Linux version (root@lubuntu10) (gcc version 4.3.3 (GCC) ) #5 Mon Oct 11 22:48:09 MSD 2010 Detected Broadcom 0x6348 CPU revision b0 CPU frequency is 256 MHz 8MB of RAM installed registering 37 GPIOs board_bcm963xx: CFE version: 1.0.37-1.5 bootconsole [early0] enabled CPU revision is: 00029107 (Broadcom BCM6348) board_bcm963xx: board name: 96348R-A Determined physical RAM map: memory: 00800000 @ 00000000 (usable) Initrd not found or empty - disabling initrd Zone PFN ranges: Normal 0x00000000 -> 0x00000800 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0x00000000 -> 0x00000800 Built 1 zonelists in Zone order, mobility grouping off. Total pages: 2032 Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200 PID hash table entries: 32 (order: -5, 128 bytes) Dentry cache hash table entries: 1024 (order: 0, 4096 bytes) Inode-cache hash table entries: 1024 (order: 0, 4096 bytes) Primary instruction cache 16kB, VIPT, 2-way, linesize 16 bytes. Primary data cache 8kB, 2-way, VIPT, no aliases, linesize 16 bytes Memory: 5208k/8192k available (2138k kernel code, 2984k reserved, 367k data, 156k init, 0k highmem) Hierarchical RCU implementation. RCU-based detection of stalled CPUs is disabled. Verbose stalled-CPUs detection is disabled. NR_IRQS:128 Calibrating delay loop... 254.97 BogoMIPS (lpj=509952) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 NET: Registered protocol family 16 registering PCI controller with io_map_base unset bio: create slab at 0 Switching to clocksource MIPS NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 512 (order: 0, 4096 bytes) TCP bind hash table entries: 512 (order: -1, 2048 bytes) TCP: Hash tables configured (established 512 bind 512) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 audit: initializing netlink socket (disabled) type=2000 audit(0.240:1): initialized squashfs: version 4.0 (2009/01/31) Phillip Lougher Registering mini_fo version $Id$ JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. msgmni has been set to 16 io scheduler noop registered io scheduler deadline registered (default) gpiodev: gpio device registered with major 254 bcm63xx_uart.0: ttyS0 at MMIO 0xfffe0300 (irq = 10) is a bcm63xx_uart console [ttyS0] enabled, bootconsole disabled console [ttyS0] enabled, bootconsole disabled bcm963xx_flash: 0x00400000 at 0x1fc00000 bcm963xx: Found 1 x16 devices at 0x0 in 16-bit bank CFI mfr 0x00000020 CFI id 0x000022c4 Amd/Fujitsu Extended Query Table at 0x0040 Amd/Fujitsu Extended Query version 1.0. bcm963xx: CFI contains unrecognised boot bank location (67). Assuming bottom. number of CFI chips: 1 bcm963xx_flash: Read Signature value of CFE1CFE1 bcm963xx_flash: CFE bootloader detected bcm963xx_flash: CFE boot tag found with version 6 and board type 96348R-A bcm963xx_flash: Partition 0 is CFE offset 0 and length 10000 bcm963xx_flash: Partition 1 is kernel offset 10100 and length dff00 bcm963xx_flash: Partition 2 is rootfs offset f0000 and length 100000 bcm963xx_flash: Partition 3 is nvram offset 1f0000 and length 10000 bcm963xx_flash: Partition 4 is linux offset 10000 and length 1e0000 bcm963xx_flash: Spare partition is 1f0000 offset and length 0 Creating 5 MTD partitions on "bcm963xx": 0x000000000000-0x000000010000 : "CFE" 0x000000010100-0x0000000f0000 : "kernel" mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only 0x0000000f0000-0x0000001f0000 : "rootfs" mtd: partition "rootfs" set to be root filesystem split_squashfs: no squashfs found in "bcm963xx" 0x0000001f0000-0x000000200000 : "nvram" 0x000000010000-0x0000001f0000 : "linux" bcm63xx_enet MII bus: probed bcm63xx_wdt started, timer margin: 30 sec TCP westwood registered NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear <> All bugs added by David S. Miller <> jffs2_scan_eraseblock(): End of filesystem marker found at 0xf0000 jffs2_build_filesystem(): unlocking the mtd device... done. jffs2_build_filesystem(): erasing all blocks after the end marker... done. VFS: Mounted root (jffs2 filesystem) readonly on device 31:2. Freeing unused kernel memory: 156k freed awk: /proc/cpuinfo: No such file or directory awk: /proc/cpuinfo: No such file or directory eth1: link forced UP - 100/full - flow control off/off roboswitch: Probing device eth0: roboswitch: [/home/texas_88/trunk/build_dir/linux-brcm63xx/kmod-switch/switch-robo.c:125] SIOCGETCPHYRD failed! roboswitch: [/home/texas_88/trunk/build_dir/linux-brcm63xx/kmod-switch/switch-robo.c:125] SIOCGETCPHYRD failed! No Robo switch in managed mode found, phy_id = 0xffffffff roboswitch: Probing device eth1: found a 5325! It's a 5350. - preinit - Press the [f] key and hit [enter] to enter failsafe mode - regular preinit - - init - Please press Enter to activate this console. bcm63xx_enet bcm63xx_enet.0: attached PHY at address 1 [Broadcom BCM63XX (1)] eth1: link forced UP - 100/full - flow control off/off device eth1 entered promiscuous mode br-lan: port 1(eth1) entering forwarding state br-lan: port 1(eth1) entering forwarding state PPP generic driver version 2.4.2 ip_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 24 nf_conntrack version 0.5.0 (83 buckets, 332 max) bcm63xx-spi bcm63xx-spi.0: at 0xfffe0c00 (irq 9, FIFOs size 63) v0.1.2 BusyBox v1.17.2 (2010-10-11 22:18:20 MSD) built-in shell (ash) Enter 'help' for a list of built-in commands. _______ ________ __ | |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D O M KAMIKAZE (bleeding edge, r23118) ------------------ * 10 oz Vodka Shake well with ice and strain * 10 oz Triple sec mixture into 10 shot glasses. * 10 oz lime juice Salute! --------------------------------------------------- root@OpenWrt:/#


toh/us.robotics/usr9107.txt · Last modified: 2015/12/12 08:23 by tmomas