User Tools

Site Tools


toh:widemac:sl-r7205

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
toh:widemac:sl-r7205 [2014/08/13 16:18]
rspliet Add warning about configuration problems of the Widemac image
toh:widemac:sl-r7205 [2014/08/14 15:32] (current)
rspliet Add configuration for VLAN
Line 56: Line 56:
  
 choose 2, then answer the prompts. Note that option 1 does not work with the sysupgrade image; booting will fail on finding the root partition. choose 2, then answer the prompts. Note that option 1 does not work with the sysupgrade image; booting will fail on finding the root partition.
 +
 +After installation,​ copy-paste the following configuration into /​etc/​config/​network
 +  config interface '​loopback'​
 +        option ifname '​lo'​
 +        option proto '​static'​
 +        option ipaddr '​127.0.0.1'​
 +        option netmask '​255.0.0.0'​
 +  ​
 +  config globals '​globals'​
 +        option ula_prefix '​fd37:​bd9a:​2b09::/​48'​
 +  ​
 +  config switch '​switch0'​
 +        option enable '​1'​
 +        option enable_vlan '​1'​
 +        option reset '​1'​
 +  ​
 +  config switch_vlan
 +        option vlan '​1'​
 +        option device '​switch0'​
 +        option ports '0 6t'
 +  ​
 +  config switch_vlan
 +        option vlan '​2'​
 +        option device '​switch0'​
 +        option ports '1 2 3 4 6t'
 +  ​
 +  config switch_port ​                                        
 +        option port '​0'​
 +        option pvid '​1'​
 +  ​
 +  config interface '​lan'​
 +        option force_link '​1'​
 +        option type '​bridge'​
 +        option proto '​static'​
 +        option ipaddr '​192.168.1.1'​
 +        option netmask '​255.255.255.0'​
 +        option ip6assign '​60'​
 +        option _orig_ifname '​eth0.2 wlan0'
 +        option _orig_bridge '​true'​
 +        option ifname '​eth0.2'​
 +        option nat '​1'​
 +  ​
 +  config interface '​wan'​
 +        option proto '​dhcp'​
 +        option _orig_ifname '​eth0.1'​
 +        option _orig_bridge '​false'​
 +        option ifname '​eth0.1'​
 +        option broadcast '​1'​
 +
 +Reboot, and the network ports should be operational.
  
   WARNING: The current OpenWRT image does not contain a valid configuration for the various wired network ports   WARNING: The current OpenWRT image does not contain a valid configuration for the various wired network ports
-  on the device. As a result, wired networking ​is currently ​broken.+  on the device. As a result, wired networking broken ​until copy-pasting in the above configuration.
  
   - -> [[doc:​howto:​obtain.firmware]]   - -> [[doc:​howto:​obtain.firmware]]
toh/widemac/sl-r7205.txt · Last modified: 2014/08/14 15:32 by rspliet