User Tools

Site Tools


toh:surecom:ep-9600-gp

Surecom EP-9600-gp

The Surecom EP-9600-gp is an wireless acccess point with two antennas.

The board should be the same as D-Link DWL2100AP

Under Construction!
This page is currently under construction. You can edit the article to help completing it.

Supported Versions

Version/Model Launch Date S/N OpenWrt Version Supported Model Specific Notes
EP-9600-gp A1 :?: - Backfire 10.03.1 :?: -

NOTE: Untested: information based on D-Link DWL2100AP.

Hardware Highlights

SoC Ram Flash Network USB Serial JTag
Atheros AR2313A@ :?: 16MiB 4MiB 1 No Yes Yes

Installation

Please refer to D-Link DWL2100AP.

Hardware

Info

Instruction set: MIPS
Vendor: Atheros
Bootloader: VxWorks
System-On-Chip: Atheros AR2313A
CPU @Frq :?:
Flash size: 4 MB
Flash Chip: Spansion S29GL032M90TFIR4
RAM size: 16 MB
RAM Chip: ESMT M12L128168A
Wireless: Atheros AR2112A :?: w/ 2 external antennas for 802.11b/g
Switch: IC+ IP101A
Modem: none
USB: No
Serial: Yes
JTAG: Yes

Photos

Front:

Back:

Opening the case

Note: This will void your warranty!

  • Remove two screws under the AP
  • Gently unhook two latches in the front

Main PCB

Serial

port.serial general information about the serial port, serial port cable, etc.

Serial console could be plugged to JP1: connector lacks, it has to be soldered on the board.

For further instructions please refer to the D-link DWL-2100AP page.

The settings are: 9600 bauds, 8 bits, no parity, 1 stop bit (9600 8N1)

terminal configuration
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control None

JTAG

port.jtag general information about the JTAG port, JTAG cable, etc.

Jtag pins are located in J1, but the connector lacks. The pinout and specifications should be the same of D-link DWL-2100AP

Notes

This Access Point should use the same board as D-link DWL-2100AP; so everything on there should also apply to this model.

Tags

toh/surecom/ep-9600-gp.txt · Last modified: 2015/12/19 12:32 by tmomas